Roasted Frenched Rack of Lamb with Cap on indoor grill

Roasted Frenched Rack of Lamb with Cap

Lamb roast can sound intimidating to most people, including experienced cooks. However, this recipe is amazingly simple and even more amazingly delicious. By following a few simple steps and trusting to the Cinder you’ll experience juicy, tender, rich meat in an impressive roast.

A note: “Frenched” lamb refers to the process of removing the thin layer of meat and fat on the ends of the bones.  This layer is prone to overcooking and spoiling the flavor of the whole roast. Also, the bare bones contrast with the lush meat for a more elegant presentation. However, if you can, get the butcher to give you those scraps; you can make a delicious by browning them in a saucepan with a handful of onion, then adding beef broth, simmering while you roast the lamb, straining and finishing with salt and pepper.

Roasted Frenched Rack of Lamb with Cap

Serves 2-3 people

Ingredients: 

  • 1 each (approx. 3 pounds) Frenched Rack of Lamb with Fat Cap
  • ½ cup Dijon Mustard
  • 1 tsp Paprika
  • 1 tsp Onion Powder
  • 1 tsp Garlic Powder
  • 1 Tbsp Kosher Salt
  • 1 tsp Black Pepper, Ground
Roasted Frenched Rack of Lamb with Cap

Method: 

  1.  Remove the lamb from the package and rinse thoroughly with cold water.  Pat dry and, using a sharp knife, trim the fat on the top of the loin to an even layer no less than ¼ inch.

  2. Tie the roast with butcher twine to create a uniform thickness in between each rib bone

  3. Brush the roast with mustard on the fat and the underside as well.

  4. Combine seasonings and cover evenly around the roast

  5. Place the roast with the fat side up on the cinder grill and close the lid. 
    Set the Cinder to 110 degrees Faranheit. (approximately 2 - 2.5 hours)

  6. Once the temperature is reached, lift the lid and flip the roast over to have the fat side down.  Close the lid and increase the temperature to 275 degrees Faranheit and insert a probe thermometer in the meat to monitor its progress

  7. Continue to cook until an internal temperature of 130 degrees Faranheit.  Remove the roast from the grill and allow to rest for 10 minutes on a cutting board.  The roast should be golden brown and tender

  8. Carve in between the each rib bone and serve right away

       Get Cinder Now

      Never Overcook Again

      Try this on Cinder Grill Today 

       Get Cinder Now

      Related Posts

      Fluffy Scrambled Eggs
      Fluffy Scrambled Eggs
      More custardy than fried eggs and less formal than an omelet, no egg dish is more comforting than scrambled eggs. Aft...
      Read More
      Seared Bay Scallops with Serrano Ham and chilies
      Seared Bay Scallops with Serrano Ham and chilies
      Winter is the best time of year to enjoy New England’s seafood bounty.  The chilled, clear waters are cleaner and bet...
      Read More
      Chateaubriand Roast
      Chateaubriand Roast
      This technique uses the Cinder grill in a reverse way that will also speed up your cooking of this tender cut of meat...
      Read More